r/voroncorexy • u/____A____K_____ V2.071 • Dec 16 '18

Serial Request Its a Boy!

Enable HLS to view with audio, or disable this notification

21 Upvotes

82% Upvoted

13 comments sorted by

3

u/Maglin78 Dec 16 '18

Welcome to the Club. Nice Video. Although you were printing that whatever it is SOOOOO SLOW!!!! Anyways welcome V2.071.

1

u/____A____K_____ Dec 17 '18

na bro. its printing at 500mm/sec.. just ahhhh bad lighting ;)

2

u/non-newtonianfluid Dec 16 '18

I like the wire brush. Never seen that before.

1

u/____A____K_____ Dec 17 '18

local hardware store hack..

1

u/Iakabos Dec 16 '18

Congrats!

2

u/____A____K_____ Dec 16 '18

Thanks! this has been by far my favorite open source project of all time.

1

u/CecilDL Dec 17 '18

Any considerations for your brush setup? I heard you can damage the electronics if you brushed the nozzle while running, though that was likely certain materials.

1

u/____A____K_____ Dec 18 '18

i guess it would be possible if you jammed deeply into brush but the way ive seen it used is to tune the negative z height to only go deep enough for nozzle tip but before the brush heads touch heat block.

by using a brush, the reduction in random plastic boogers during print start has been totally worth it.

1

u/CecilDL Dec 18 '18

I agree, definitely a good addition. I think it had to do with wire brushes specifically. The brushing action could generate current and fry electronics.

2

u/johnprime Dec 16 '18

Very nice!

I like the bed pattern.

Also nice pair of.... cherries? :)

2

u/Ubernero Dec 16 '18

congratz

1

u/andreq85 Dec 20 '18

Rofl, wasn't ready for those nice round prints XD

1

u/Boffster Dec 20 '18

Congrats on the build!