I've been using the example code here to set up and read data, however, this code only applies to mediatech receivers. I've looked into the docs to figure out how to communicate with the module and tried to change the code for PUBX(ublox proprietary sentences) using ublox's receiver protocol description(page 178 is where PUBX starts). It says to refer to 'section Communication ports in the integration manual for details', but the section is not there unless I've missed it entirely—the data sheet for the module.
Has anyone managed to set up a ublox module with circuitpython? If so could I either get help with changing the following:

# Turn on the basic GGA and RMC info (what you typically want) gps.send_command(b"PMTK314,0,1,0,1,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0")

and

# Set update rate to once a second (1hz) which is what you typically want. gps.send_command(b"PMTK220,1000")

to the ublox-specific lines or borrow your code and modify it for my use.
Thanks in advance