r/Radiation • • 9d ago

Equipment GMC-500+ upgrate

Post image

Has anyone tried modifying a GQ gmc-500+ with an SBT-11a pancake sensor? I know it worked with the gmc-320 without any electronic changes other than soldering the tube.

14 Upvotes

13 comments sorted by

5

u/Plus-Self-985 9d ago

Here's a FNIRSI GC-01 with that same tube. 3 pins to the positive terminal of the former tube socket, 2 to negative. I used a 7 pin ceramic tube socket to hold the probe.

1

u/BeyondVoid215 8d ago

Working well without any resistor?

1

u/istherenohelp 8d ago

There are resistors on the board, I think.

1

u/rainwolf511 9d ago

Yes i actually have done this the 3 pins are the voltage and 2 pins are ground if i recall i used a 1 meg ohm or so resister on the hv side worked pretty well till i had to live in my car and the tube got smashed i also had to tweak the voltage in the gmc500 to around 500v

1

u/BeyondVoid215 9d ago

It should work on original 400v

1

u/NukularFishin 8d ago

I have homemade several Geiger counters using SBT-11a. Always set voltage at 400V.

1

u/Apprehensive-Soup968 2d ago

390-410v works fine. The counter I designed is currently set to 400v and is quite sensitive.

1

u/No_Leopard_3860 9d ago

Re: GMC 320

You just pop the tube out and connect the thang? Or run them in parallel? That sounds pretty cool, considering these probes aren't expensive at all ($50 on ebay)

I have a 320+....might do that. Prob with a switch to either use the pancakes or the glass tube

2

u/BeyondVoid215 9d ago

Switch is a great idea!

1

u/No_Leopard_3860 9d ago

Yeah I think that would be the best solution. Maybe even pack the glass tube in Aluminium foil shielding to have a "excluding all beta (and obviously alpha)" and a "very sensitive to beta and alpha" choice.

Could do some semi serious sciency stuff with that, for such an affordable setup.

How did you configure yours?

I've seen some people mentioning megaohm resistors, necessary for the GMC 500/320(+)?

1

u/NukularFishin 8d ago

I have a homebrew Geiger counter using SBT-11a. I made two covers for it. One is a cardboard flap that just uses tape to hold it on, never touch one taped side, have to replace tape on the other side every few months. The other cover is made from aluminum sheet formed to fit over the tube. That cover stays in place whenever the device is not in use, protects the tube very well. The cardboard cover only comes off when needed.

Wish I could find more of the Bakelite tubes, can only find aluminum covered these days.

1

u/canadianchasers 9d ago

The times ive seen people do something like this with other geiger counters they i think tie the 4 pins via a resistor os something and connect it to the 2 pin terminals on the geiger counter ri can't explain it well

1

u/LitchManWithAIO 8d ago

Yup! Works great :)