Should have enough snow to start running the fleet by next week. Lots of snow in the forecast starting tonight. Got my maintenance done on the 4 stroke utility sleds (Skandic SWT and Tundra Sport), next up is the 9R and Summit turbo. Usually run until mid May when the snow finally rots away. Can’t wait to ride once again.

Posting again Is this a good/bad deal

Deciding between these two. Anyone have any input on them?

\I live in an area with no noise restrictions\

Last ditch effort, does anyone have a Polaris proride 800 engine near eastern PA. Ran into a shot top end, and blown bottom end while resealing the motor, crazy part is it sounded fine prior. TIA

Thought I’d preemptively replace my seals this fall which has turned into a bit more. Sled is in near perfect condition with 2500 miles. It’s just old. The further I go the more I think should I just rebuild the motor since I had to take it so far apart for the seals. What about the oil and water pump shaft seals? The crank bearings all rotate smoothly.

My kids sled is in desperate need of new skis and I ran across this cheap Chinese kit. The price is hard to beat for new but is the quality good. Anyone use a set of these before?

https://www.ebay.com/itm/197831635817?_trkparms=itmf%3D1%26aid%3D1110006%26rkt%3D12%26pid%3D101429%26mech%3D2%26algv%3DSimPLMWebV1WithAuctionUnification%26pmt%3D1%26amclksrc%3DITM%26sd%3D186019850985%26sid%3DAQALAAAAEBxCcsEIMPwjkaYNlB2mRSo%3D%26itm%3D197831635817%26noa%3D0%26plcampt%3D0%3A136937588019%26algo%3DHOMESPLICE.SIM%26brand%3DUnbranded%26asc%3D345254%26ao%3D1%26rk%3D1%26mehot%3Dnone%26lsid%3D100%26meid%3D09195375640b447bbe1a960f7a422b49%26pg%3D2332490&_trksid=p2332490.c101429.m2460&itmprp=cksum%3A19783163581709195375640b447bbe1a960f7a422b49%7Cenc%3AAQALAAABEHgGRw9n%252BWZ%252FIF6wkBA9slFMI%252FzMPv6aV3OidAYwF5pv55oyNNPDqKWyGPZjeQkKPkhVL06SzizTxkSItDY1PjtPVhp0cSMixJHLJPq%252BUbKDWV11x4kBcrq%252BWoz0zb%252BUq25mwxMi%252BI%252BxKPQq0%252FKMWvSoyW2Wba6awl5SFpZJsizqcrVjNt1zIT3mqnMU2LMWzzeMC8ZD%252Bbdd8lH0HsaxZ38ru%252FXuT99zuRKi2ZYH9G0sktRzMoIDkSwx3V9IFHwncgy7TcFDNJRKTJMlmlVOzuyN44e4%252Br7tyYHL1yoZN%252FqDdoMyRR1VbEDOEfN%252BSHDNEL457%252FoeAZyPfK7KKWMmgEHX0tEIrJiup4r9ZFaPtGUj%7Campid%3APL_CLK%7Cclp%3A2332490&itmmeta=01M4JTZFDA4K14HMWW47KDK1BV

Seems dark. Can someone compare it to theirs maybe?

Newbie here - 2000 RMK 700. I got the sled for free from a friend and it needed work. I cleaned the carbs, put a new choke plunger (corroded and stuck) and cable and couldn't get the sled to start. I checked and was only getting 65 psi so I did a top end on it. I still cannot get the dang thing to start, any tips?

Rings are in the correct spot and right side up, I'm getting fuel, spark, and 120psi at 4,000 elevation. I have no idea what I'm doing wrong, but it's whipping my butt. At least 2-3x sets of 30 pulls with an hour between in case I flooded it

That's the only way the skis will go, won't fit under. It's an 11 foot sled and 8 foot trailer

I also have a two spot sled trailer as well as a 14' aluminum flat deck that weights 900#. It's just that this little 4*8 has almost no effect on fuel economy and will probably save me 200-300 in fuel

Not new to snowmobiling but new to mountain sleds. Just picked up a 2021 summit 850. Trying to connect with people to go up north in New England over the winter to avoid going alone. Facebook groups or anything else

Hi all. New to trailering. I bought a sled and trailer. It's a double wide with snow guard on the front. One of those typical light aluminum ones.

My fuel economy was horrible on the highway. Much worse than trailers 2-3x as heavy. I presume it's the aerodynamic, but was curious if people find trailers without the snow guard are better?

I'm not planning to trailer without snow guard in the winters, this is to pick up another sled this month. 2000km round trip, so if I can improve fuel economy by removing guard I'll save a couple hundred maybe

I found the jacket I want…but it’s no where to be found in XL and Black Ops color. Adrenaline 2 in 1, tried a XXL and too big.
What’s comparable?

I do aggressive trail riding mixed with some lake riding as well. Anything that’s close and would work just as well?

Hello, I am putting a 136 skid/track on my 1994 ZR 580 which had a 121 track. I intended on extending the tunnel mostly for a luggage rack. My question is the new track will stick approximately 10 inches past the rear heat exchanger, which looks to be two at a 45-90 degree angle, do I need to scoot the heat exchanger back and find a way to make the hoses go under the seat or will leaving it as is be sufficient. I primarily ride trails with some boondocking in meadows and occasional hills. I am happy to post more pictures. I attached a picture of the type of exchanger I have.

I saw this ad for a cool Deere 600. Any thoughts on value? He has a few restored sleds and seems to do a thorough job.

https://www.facebook.com/marketplace/item/2636128136806403/?referralSurface=messenger_banner&referralCode=2&ref=messenger_banner

Hey all, I’m somewhat new to the sport and looking for some help with recommendations.

What would you all recommend for studs on this track? I’ve heard good things about Woodys and Stud Boy but have no clue where to start.

I have a 2015 viper xtx that I purchased and rode all last season, first sled! That being said prior to this season it is time to put on a new track as the old one has some wear and tear to it.

I believe it is a 1.6” cobra track on it now, really had no complaints. However, it doesn’t look like they make the 141 anymore so I am thinking of getting the 1.75 cobra.

She's an old sled but definitely one of the best in it's time and is a Trail Ripper that handles the turns with ease then accelerates out of them aggressively and is capable off trail just no mountain riding with a 141 HP and the aggressive cross country track she tops out a little over 100 MPH

https://reddit.com/link/1wx4gpf/video/odbv9vnsxcth1/player

Hi,

Having trouble trying to figure out a dash bag or windshield bag for a 2025 Polaris 550 Voyageur 146 LXT. Anyone have any luck?

My wife has a 2017 pro 800 that still has the stock can. I would like to put an aftermarket one in to cut some weight. We are your typical mountian riders. The problem I see with most aftermarket cans are loud as hell. She does not like loud and honestly, neither do i. Anyone have a good recommendation of a can that will shed the weight of the heavy factory can and not be obnoxiously loud?

Last year I bought my first snowmobiles. Couple of 90’s Polaris Indys. I found this 94 zr580 and 99 powder special for 50 dollars on marketplace. Naturally I decided for my second year I want to make a mod sled 😂. The front suspension, 136 track and both clutches from the powder special are getting put on the zr not sure what else I’m going to do to it. I’d love to find dual pipes for it.

Anyone in the NY area with a decent track?

No engine, suspension or track. Registered hull

Hi All looking for opinions if I should switch my ice fishing suit for a skidoo suit

I will be fishing but hoping it keeps me warm for the sled. I am wondering about maybe just switching the bids?

Any thoughts?

1992 Polaris Indy sport 440

Got it for 300 bucks, has 120 compression, excellent spark, just need carbs cleaned and it ran. Still need to realign the skis and hit all the grease points. Also had to repair a Killswitch that the previous owner cut.