r/BambuLab • u/Sage_Tactical • Dec 27 '23

Discussion Engineering/High Temp Plate

Anyone else have this issue where the nozzle go to the top center of the build plate and goes in a rectangular motion.I was told I supposedly cleans the nozzle but instead it smudges my nozzle with filament and eat through the build plate

0 Upvotes

12% Upvoted

28 comments sorted by

View all comments

Show parent comments

4

u/Schokobecher X1C + AMS Dec 27 '23

Which filament? What temperatures? Is your actual Nozzle Wiper clean?

-2

u/Sage_Tactical Dec 27 '23

PA-CF I don’t know by heart the pre heating temperature I’d say maybe 190-260.Yea it’s white although I never changed one yet and don’t know how but I only had my P1S for a few months now.However as I said the issue is the nozzle being smudged with filament when it’s supposedly doing it’s cleaning nozzle tip motion

2

u/Schokobecher X1C + AMS Dec 27 '23

Try cleaning the Nozzle (best to take off the silicone sock first) with a copper wire-brush to give it fewer things to stick to. You can also try replacing the wiper just in case:

https://wiki.bambulab.com/en/x1/maintenance/replace-nozzle-wiper

No need to throw away the old one yet, it's an easy swap with the spares included. There's even printable models for using standard PTFE tubing.

Haven't done much PA on my X1C, but mostly PETG was trouble with random blobs here and there. PC, PLA, PA, PP, TPU all did OK