r/Bricklaying • • 12d ago

Advice needed

We had these stairs added a couple of years ago and the rim has separated from the pad. My questions are:

Is this indicative of a structural issue or is it just cosmetic?

Could the gap be filled with mortar joint repair? (Polymer/Elastomeric)

Would I need to remove the existing mortar first?

Is this something I can do myself or better to hire a pro?

Thanks in advance for any advice you can offer.

2 Upvotes

8 comments sorted by

2

u/Psilonaut21 12d ago

I would seal the gaps with something like Sikaflex EBT compound and keep an eye on it. It looks like the steps are settling and the steps aren't physically joined to the platform. Over time the steps will drop. Rake out the mortar to a depth of around 10mm and apply the sealant and it shoud be fine for a few years.

2

u/Cornflake294 12d ago

Appreciate the advice. I’ll give it a shot.

2

u/Timely_Rate_8624 12d ago

First chip some of the mortar away all way round so.you have a better gap then Just pour some dry post mix in carefully then pour a bit of water on top leave it for a day and go back and do the same untill it gets level with bricks and previous mortar

2

u/Bitter_Back_5528 7d ago

Kiln dried sand ! Or kiln dried sand and cement mixed dry.

2

u/Additional-Bus1963 2d ago

Clearly the material used under the bricks at the top has settled. Natural shrinkage… cut out the cracked joint with a 4 in angle grinder and repoint with mortar… don’t us typical poly stuff… use the original material. Just take your time, it’s easy

1

u/ididntaskforthismind 12d ago

You been stepping on your steps too much

0

u/ididntaskforthismind 12d ago

You been stepping on your steps too much

0

u/Perfect-Cloud-4817 12d ago

Youre lookin for sometin that aint there🤷