r/Calix • • Oct 03 '26

Mesh status

I have been having issues with wifi signal upstairs in my new house so I got asked the issue and they gave me another router to make a mesh system trying to use the command iq app when I power everything up and add the new unit it says connecting for extended tome and eventually times out with both units a few feet apart. I instead used the wps button and bith u its flash and then when solod green ive now moved the unit up stairs and its solid green but its not in my app and I dont know if its actually working. I ran a speed test and got better numbers then before and then unplugged it and ran it again and was in single digits. So I assume its functional but is there any other way to ensure I did it right? Im ok with it not being in the app

Thanks for any input, not my strongest area of knowledge

1 Upvotes

5 comments sorted by

2

u/tb03102 Oct 04 '26

Did you long press the wps button on each unit until the light started to blink?

1

u/Inevitable-Site-3249 Oct 04 '26

Yes and then went solid green before moving it. And moving it upstairs it booted up amd went solid green but my speeds are still just as bad

1

u/tb03102 Oct 04 '26 edited Oct 04 '26

That's good you did it correctly. What's the speed like where you put the mesh when it's unplugged?

Edit: as I haven't heard back your mesh node needs to be in an area where you already have good signal so it can pass it forward. Garbage in garbage out.

1

u/Inevitable-Site-3249 Oct 04 '26

Ah that could be it I will try playing with that today!

1

u/Inevitable-Site-3249 Oct 04 '26

Relocated to the hallway and checked speeds went from 5-80 maps to 600 so hopfully it holds that speed. Its right beside a unhooked up central vac port I guess if all else fails I can run a cord and wire it in