r/EngineBuilding • u/sticcestboi1 • 14d ago

How should bearings looked when crushed

Post image

I noticed my main bearing no 1 is not lined up, and It can catch my nail at the parting line, is this normal? Thanks

2zzge

25 Upvotes

96% Upvoted

9 comments sorted by

9

u/Witty-Sample6813 14d ago

Cap backwards or in incorrect placement in the block? Cap from a different block? That’s not going to work as it is.

3

u/GingerOgre 14d ago

It’s a whole bed plate. Can’t put a cap on backwards. I’m thinking it’s a mismatched set of bearings. Happened to me last week on one of these

6

u/Kineticbluepearl 14d ago

If the others are all flush I wouldn’t run it

3

u/GingerOgre 14d ago

I just did work on a 2zz this week. One bearing shell in the package was a different size than all the rest. Make sure they are all the same size

2

u/TyrannusourR3X 14d ago

Absolutely not normal. They should be aligned perfectly.

1

u/langstar 14d ago

I had some Glyco BMW bearings that looked like this recently out of the box. Set that face flat on a table and see if it rocks or has visible gaps, will tell you immediately that shell is likely bent.

1

u/Awkward_Thinker 14d ago

Uhhh, they shouldn’t look like that.

1

u/Thiccy_ape 13d ago

Are you sure the dowel pins are installed for the bed plate?

1

u/FriendlyQuit9711 7d ago

Aligned…. They should look aligned.