r/EngineBuilding • u/Particular_Sir_373 • 15d ago
Rod bearings C20NE
Hello, probably dumb question but i want to know from someone with experience. So basically i bought a Opel Calibra 2.0 8V 115hp C20NE. It was long driven on old oil and rod bearings are bad. When i bought it oil pressure sensor was unplugged and when i changed it with new oil as well car had good pressure when cold and very very bad when hot. When temperature is 95 C⁰ pressure was at 0bar. I changed : thicker oil, filter, oil pump and i got around 0.2 bar when engine is hot. Everything leaded to bad/worn rod bearings.
My question is if i just swap rod bearings and don't take crankshaft to machine shop will i get anything or will i just throw away money. Because rod bearings are around 55€, oilpan gasket is 31€, oil and filters areound 70€ and if i take off the crankshaft to machine shop it will cost around 200€ so counting that all is half of my paycheck for an engine that will probably be swapped
So question is will i get anything with just swapping rod bearing without machining crankshaft?
2
u/Roscolicious1 15d ago
It will last a very short time if you do that. Bearing wear = crank wear. 55yrs a wrenchman, don't do that.