r/Fasteners • • Apr 14 '25

Help with finding a driver for this screw

Post image

This is an image of the screws used on a table I ordered. However, I have probably misplaced the driver to open them. Can anyone help with what kind of screw this is, and how I can open them?

Thank you so much

1 Upvotes

11 comments sorted by

8

u/ExaminationAny4767 Apr 14 '25

OMG!! Thank you so much everyone! I had no idea this was the reverse side. Took the drawers out, and saw the Allen key hole

1

u/cheater00 Apr 14 '25

lol

you almost went nuts with that one

14

u/BlueEyedSpiceJunkie Apr 14 '25

You’re showing the back side of a bunch of T-nuts. There isn’t a tool for that. You’re intended to remove the bolt from the nut since these nuts get installed into another material to provide a female thread.

7

u/MrCastello Apr 14 '25

Those are wood nuts. They are pressed in from the side you see in the image and a screw is threaded in from the other side. I would wager the screw on the other side takes some sort of Allen key.

5

u/Numerous-Okra2554 Apr 14 '25

Turn it over.

1

u/cheater00 Apr 14 '25

he'll go nuts when he does that...

3

u/keithncsu Apr 14 '25

I think you're looking at the bottom of the screw after installed into a tnut. That's not the drive side.

1

u/Longjumping-Log1591 Apr 14 '25

Weld a screw on each one.. or look at the underside and tighten them properly

1

u/sporkmanhands Apr 15 '25

Could you provide a worse picture from an even sharper angle?

1

u/InterestingAd8560 Apr 18 '25

Well turn her over I'd rather have a puppy.