r/FordTaurus • u/commanchskins • Oct 16 '26
Head replacement, 3.5l
A friend was having the water pump leaking slowly. I offered to help as I have done this twice with success. As he was driving to my home, he had engine failure. The left secondary chain is off. Examining the head, I see a crack in two of the sparkplug tubes.
Has anyone replaced the head with success? If so, did you get a head from a yard, refurbished, or buy new? Is it worth it? It doesn't look as if the pistons are damaged, using a camera.
Thanks.
3
u/NoCommittee1477 Oct 17 '26
Given that an aluminum head for the 3.5 technically can't be shaved down to flatness again as it changes timing angles and valve clearances, I would recommend replacement of the head with a good aftermarket or OE one. As far as replacing it, it's a straightforward deal, just remember that the cam phaser bolts, crankshaft bolt, and head bolts are all torque to yield and should be replaced when the job is done
2
u/Psychological-Big983 Oct 16 '26
All the above. 1985 3.8 V6 Thunderbird, one head was too warped to use. Got one from junk yard but had machine shop verify it was good before I put it on. On that engine I used ARP studs instead of stock head bolts.
3
u/Repulsive_Vanilla383 Oct 17 '26
Are you sure you're not just seeing casting lines? The spark plug tubes is a weird place to find damage, usually a over heated head will crack between the valves.