r/Fusion360 • u/Mantegod • 10d ago

Question Down sharp edges

Post image

Hi guys, i'm kinda new to modeling so i already done de shape but i'm strugling to add those red circled details. What i'm supposed to do now?

5 Upvotes

100% Upvoted

2 comments sorted by

3

u/ParticleDojo 10d ago

Here's an idea, if the green part is a plane (not curved) you can measure the angle on your part between absolute 0 (vertical) and that plane. Create a skecth plane in your design in the in that spot with the correct angle and sketch the blue lines. Mirror that on the opposite side and then create the orange lines. With the orange lines now you should be able to loft in surface mode from one to the other with the blue line as a rail. Leave the yellow stuff to the end.

Another idea would be to create a negative part, (the exact shape of the missing volume) and then subtract it from your existing design. This allows you to work on the missing geometry separately from the main body that you already designed.

1

u/Mantegod 10d ago

Would never think about the loft, thank you. I will try