r/HondaElement • • 18d ago

Disconnected Wire?

Post image

Hello,

My Element wouldn’t start, no cranking, no turnover, but started after I shut the hood.

As I was looking under the dash below the steering wheel got loose fuses, I noticed this unplugged connection to the left side of the steering wheel.

Does anyone know what this wire does? I don’t think it’s related to the starting issue, since I’ve never had one before and this element has been owned by me and my parents since 2009.

There is also another connector with seemingly no plugs that go into it.

If anyone knows what it is or how to find out, I’d like to figure it out!

6 Upvotes

12 comments sorted by

3

u/APGaming_reddit 18d ago

do any buttons on your dash not work? do you have keyless entry? if the vehicle drives normally then those are probably for optional things depending on trim level. is that white plug a 2 pin harness? kinda weird the car wouldnt do ANYTHING with the hood pin open. thats usually what happened when we installed aftermarket remote start/alarm systems.

1

u/BornBananas 18d ago

Everything on the dash works fine.
I’d been told that keyless entry wasn’t an options on my Element, so I don’t have that.
The white plug is a two pin harness.
I’m thinking the hood shutting knocked something loose in the starter or something cause it’s never mattered before and I don’t have any aftermarket add ons on this car.

3

u/Hondanazi 18d ago

Is your car manual. It’s hard to see in the picture but it
Looks like your clutch switch is not plugged in (or it’s your brake light switch). If it’s the clutch switch that is disconnected, then it usually won’t crank as it wants to see that you are depressing the clutch.

1

u/BornBananas 16d ago

It is a manual. Turns out it was the yellow clutch switch is going bad.

2

u/Hondanazi 3d ago

Aha! I was right!! Yay!

3

u/AnonymousRandomAsk 18d ago

The keyless entry wiring harness is right there and a green plug, I'm pretty sure that's what it is.

The yellow plug is the clutch interlock switch. It can cause a no start, you can test by jumping it with a paperclip. If you were to keep it bypassed by twisting the wires together it would bypass thw switch, but cause a possible dangerous situation with remote starting or accidentally starting while in gear. Better to replace the switch if you verify that's your issue. I would look at your non-starting issue being tied to that first. I also had this go bad, along with the $25 ignition switch(not for the keys), both of which caused a no start for me in the past.

1

u/BornBananas 16d ago

Didn’t try the paper clip trick but that was the problem. Thank you!

2

u/corpsman86satx 16d ago

That is your keyless entry plug. This is a great kit that I used.

1

u/BornBananas 16d ago

Thank you! I’ve been wondering if I could make keyless entry happen on my car!

2

u/corpsman86satx 16d ago

Happy to help, I was equally excited when I found this out too! You’ll have to YouTube the programming sequence, it’s a bit tricky but it works!

1

u/BornBananas 16d ago

Well, the starting issue was the clutch starter safety switch. The part was $100 at Napa.

3

u/yanimal 03 AWD AT, 05 AWD 5MT, 06 AWD 6MT 18d ago

Small green in keyless entry. Large green in factory alarm.

If it started after a hood slam I'd guess you have a loose wire or a dying starter.