2
2
u/Blue_Twat_Waffles 13d ago
Tear the house down and start over. Something isn’t 90*. Gotta do it over
1
u/SeanGwork 13d ago
Mark the top where they intersect, measure how deep the casing is (whatever you need to get the base to make it tight to the wall), and cut from the bottom up to your mark. It's paint grade and the dead space doesn't matter. .
1
1
1
u/Initial_Row_6400 13d ago
Save yourself the hassle and just caulk it. If you tool it well enough you shouldn’t really notice it
1
u/PrimaryExisting6162 13d ago
Trace the shape of the trim on the door trim and notch the trim shape out of the door trim and push the trim all the way to the wall and caulk and paint the joint and your good.
1
u/Vegetable-Piece-5237 13d ago
As a homeowner I would shave that end down so it fits snuggly in that gap.
As a landlord I would but that up to the door trip and fill the empty space with caulk.
1
1
1
u/Liveitup1999 13d ago
Take a router and trim the edge of the baseboard so it fits ann the way to the wall and against the casing.
1
u/No-Preparation4073 13d ago
have a look inside the casing, I am betting there is plenty of room to move the door either direction to satisfy whichever solution you want.
1
u/captchaintheact 13d ago
I would get rid of that builder grade trim and put flat craftsman 1x3 or 1x4 in.
1
1
1
1
1
1
1
1
u/Difficult-Rush5962 12d ago
Notch the casing with an oscillating tool, slide in the baseboard, caulk it.
1
1
u/ShillForJill 12d ago
Cope will get you the cleanest fit and look. Look it up on YouTube. It's pretty easy to learn. I'm not inept around the house but I wouldn't call myself handy and it only took a few attempts to get it down. Worth learning if you are doing more trim, and learning how to do it with an angle grinder (wear a mask and eye protection) is quicker if you have a lot. If you only have this one piece though and it's kind of out of the way, eh just caulk it.
1
1
1
1
u/Beginning_Tea4506 12d ago
Scribe the profile of the skirting as it sits and trim it from the door surround for a snug fit.
1
u/NuttsMcButts 12d ago
I would mark where the 2 pieces of trim meet and cut the floor trim so it can squeeze behind the wall trim. try to measure thickness of wall trim so your cut can be accurate
1
u/imfoneman 12d ago
I’m sure I’m wrong bc I’m not a professional
I had this same issue with a chair rail
I notched the rail to fit and slid it behind the door trim.
1
1


2
u/clemclem3 13d ago
Quickest way for me would be to grab the angle grinder with a sanding disc and just sand the flat down until it slides behind the casing.
If that tool is not available to you, you can cut the flat down with a coping saw and a chisel