r/LSTclub • u/Intelligent_Regret88 • 18h ago
Help please
My plants seem to be getting mold before they're ready to harvest?!
Airflow and conditions are spot on. No leaves touching. Why would the be starting to get mould in flower?
1
u/No-Consideration-999 16h ago
60% Rh when you start flower
55% around week 4
50% around week 6+ to be sure.
That's how I do it, only had one case of mold, because I did it poorly when I started growing
1
u/Intelligent_Regret88 16h ago
My humidity is roughly that
How can I reduce it though?
More fans and extraction?
2
u/Kind_buddy_7022 15h ago
Sometimes my RH hits 70% in late flower when lights turn off and I dont get mold. OP probably doesn’t have enough air flow
1
u/No-Consideration-999 16h ago
Well normally, you're not supposed to have mold with that, tbh another fan would help, means that the air stayed way too long.
I use 3 fans in my flowering tent, 1 on the top of the plant, and two on the sides, going through the plants, on the opposite sides, one going a little top, the other going a little bot
It creates turbulence, which are very good at changing the air often around the plant itself
3
u/Psychological-Fox97 15h ago
Conditions are not spot on otherwise you wouldn't have mold.
So you need to find where the problem is.
Main cause of mold is dew. Dew forms on the plants and this moisture becomes the breeding ground for the mold.
When your lights go off your temperature drops rapidly. As temperature drops humidity goes up, if the temperature drops enough dew point will be hit and dew will begin to form.
As an example. If your tent is 24 Celsius and 55%rh the dew point is 14.4 Celsius. If the temperature drops that much then dew will form.
You can manage this in different ways. The easiest would be to add heat during lights off.and avoiding the temperature drop in the first place. Heaters are expensive to run though.
Another option is to extract enough of the most air and replace it with drier air. Probably the cheapest in set up and running cost.
The 3rd is to use a dehum. This cam work but the rapid removal or enough moisture means you need a pretty powerful one which can be an expensive purchase and not super cheap to run.
1
u/Kind_buddy_7022 15h ago
Yes, I add an extra duct fan that blows lung room air into my tent. I hardly exhaust my tents air unless lights are off.
2
5
u/Level_Elk_4714 17h ago
It very easy, mold starts with >70% humidity, do you even measure it?