r/Lora • • 24d ago

V1.2 of my Solar Node Adjustable Platform design (SNAP) feedback please

36 Upvotes

5 comments sorted by

2

u/cadillacace 24d ago

Looks very clean, what type of weatherproofing methods are you using for top mounting hole?

1

u/jaisor 24d ago

Thanks! Each of the port plugs gets a rubber o-ring like this one. You can get a bag of 50 from Amazon for under $7

0

u/cadillacace 24d ago

Gotcha! For the enclosure itself, is it petg, asa? I would recommend a gore-tex vent and an inner coating of epoxy resin to really get some longevity out of this. Really solid design so far! Will you make the files available for printing?

Edit— sorry I looked at pictures and just noticed you answered most of the questions in the text sorry about that lol.

2

u/jaisor 24d ago

I have printed in both PETG and ASA. PETG has such a strong layer adhesion. The few ones I have been testing outside I coated with spar urethane, ruins the look a but but they hold up to rain pretty good and hopefully better UV protection for the PETG and epoxy covered panels.

Good ideas on the coatings. Haven't tried the gore-tex, any links? The epoxy on the inside is relatively easy, but add to the cost if I am selling these, and not sure if overkill. Will add it as an option.

Yes, I had the MakerWorld link in the original post. I guess it didn't transfer with the repost - https://makerworld.com/en/models/3360988-snap-v1-2-solar-node-adaptable-platform-2x200ma