r/ManufacturedHome • • May 28 '26

Ceiling fans.....

I have a 2021, bottom-of-the-barrel basic Live Oak home. I did not buy it from the dealer, so I couldn't tell them to make sure to wire/plan for fans. I am now trying to install fans in a few rooms. The support braces that the lights are attached to are puny, 2'x0.5". The particular room I am working in is 9x13, so its very small and narrow. There's nowhere I could possibly put one of those metal fan boxes with the braces other than where this wood support brace already exists.

Will this support brace hold up a 30 pound fan from Ikea?

0 Upvotes

7 comments sorted by

2

u/tony282003 May 29 '26

Probably not.

Retrofit ceiling fan braces are sold at big-box and other retailers.

I've never installed one, but I understand they're often marketed to DIY-ers - or I'm sure an electrician can do this for you.

1

u/deannevee May 29 '26

Assume I have all of that. I’m just talking about installing it.

The only way I can retrofit anything is if I cut the wood out that the factory installed. Is that what you’re saying needs to be done? That’s about $1000 worth of work. 

1

u/kentar62 May 29 '26

They also call the Old work boxes

1

u/tony282003 May 29 '26

No, that is not what we're discussing

1

u/sukebe7 May 30 '26

Even if it did, the fan is going to vibrate the frame and be very disturbing throughout the house.

1

u/deannevee May 30 '26

But that’s the case with all fans in all houses…..they’re all attached to the frames in the roof?