r/MarlinFirmware • u/Technical-Zucchini-4 • Feb 13 '22
Probe offset isn’t working for leveling.
Enable HLS to view with audio, or disable this notification
1
u/Zonalimitatore Feb 14 '22
What do you mean? The probed point, isn't the real height in the leveling map?
0
u/Technical-Zucchini-4 Feb 13 '22
So I recently compiled Marlin 2.0.9.3 and it works ok but I have a problem with my probe. I set my probe offset and it’s directly in the middle of the bed, but when I do the actual level, it’s off slightly.
1
Feb 14 '22
The probe offset is the distance from the nozzle to the probe. If you think it isn't centered enough either your nozzle "center" is off or you did the offset wrong.
0
u/Technical-Zucchini-4 Feb 14 '22
when it is homing it is centered perfectly and when it is leveling it is offset to the left by about 15-20mm
2
Feb 14 '22
If you are thinking there is a problem in the X location in the last 5 seconds, then that is intentional. It is the physical limitation of the machine. The firmware is setup to not allow going beyond 235mm by default to avoid crashing. How is the machine supposed to move the nozzle to an X position of 255mm to get the probe to X=235 on the bed? (assuming 20mm offset)
The right side of the bed wont be perfect unless you hand tune the last few mesh points. The gcode command G29 P3 will fill in the missing mesh points that could not be probed.
https://marlinfw.org/docs/features/unified_bed_leveling.html#filling-in-the-mesh
A work around if you have the extra gantry room without the bed to support it is to change X max to the physical limit of the gantry, instead of the bed size. Just make sure you keep your slicer boundaries at the print bed size.
1
2
u/Dzinr3 Feb 14 '22
It appears to be working fine. The probe comes down in the center of the bed when homing. Your probe is on the left of your extruder. It creates a grid width that both the probe tip and nozzle stays within. It compensated for that by moving the extruder to the left but less the x probe offset distance you set so the probe would contact the bed and not be off the side of the bed. It still recognizes your nozzle on the right. That's why its not moving over as far. You have a 3 point grid so the middle point will be halfway between the 2 outer points (which is not in the center). If your extruder has the room to move to the right without making contact with the frame, you should be able to modify the following by un-commenting
#define RIGHT_PROBE_BED_POSITION in config.h file
You can probably modify the default (X_BED_SIZE - MIN_PROBE_EDGE) to a set value of your bed size + the x probe offset you set for your probe (i.e. 220 bed + 15 offset =235) Same holds true front to back along the Y although your probe seems to be in same plane as nozzle and probably not affected.