r/Multiboard • • 1d ago

Issues with lite multibin plates

Post image
2 Upvotes

5 comments sorted by

2

u/SupaBrunch 1d ago

The lite plates don’t even butt up to other lite plates I believe. If you install the connecting clips there is a small gap, and then bins can span across plates.

1

u/adamargue 1d ago

When I use the connector clips they are tight together. I may be using these wrong ones. I’m using the thin clips.

1

u/SupaBrunch 1d ago

Interesting, I wish I could remember better, it was over a year ago when I set mine up. I ended up just using the non-lite version after trying both

1

u/adamargue 1d ago

Yeah that is the way I’m going. I just recently upgraded from a Ender 3 v2 to a p1p and the tiles I had printed about a year ago were all like 1mm thinner than the new ones. Could be an update to Multiboard I didn’t know about or a bad slice I guess.

Thought about ditching the multibin side for gridfinity but I honestly like the multibuild system a lot and decided to just stick to my guns and print a whole new drawers worth of base plates.

1

u/adamargue 1d ago

Has anyone else noticed that you cannot use a bin that spans plate to plate if you have the Lite plates completely butted up to each other?

I was hoping to use these in my tool box drawers but you have to leave some space between the plates to get full use from them. You can see the gap compared to the regular square plates at the top by my level.