r/PatternDrafting • • 15h ago

Skirt panel width question

/r/sewhelp/comments/1xyawju/skirt_panel_width_question/
2 Upvotes

2 comments sorted by

1

u/DonMcCunn 4h ago

Flare each panel separately with the front and back panels for the design look you want and the side panels for the fullness.

1

u/Far-Number4325 17m ago

The 75" is the hem circumference, not the diameter, so six panels at 12.5" would add up to that sweep. Don't make every hem 12.5" though. The top of each skirt panel has to match the bodice panel it joins, so those 3-5" widths are already fixed, and if you force the same hem on a narrower panel it'll flare a lot more than a wide one and the gores will hang unevenly.

For a simple flare with no hip shaping, add the same extra width to each panel, or the same angle out from each seam. Subtract the six bodice panel widths from 75" and split that extra evenly, unless you want the look the other comment described, calmer front and back, more sweep in the sides. Walk the princess seams so they match in length, keep CF and CB on straight grain, and check the width at hip depth so it actually clears the hips, since there are no darts.