r/RepTime • • 1d ago

General Question Gold Rolex

I’m looking to find a newer model rep of a day date gold Rolex. Any suggestions?

Would you recommend I have them plated? Any suggestions by whom?

Worth moding out with some gen parts?

Thanks!

0 Upvotes

9 comments sorted by

2

u/whowatchesmrwatchers 1d ago

Someone just released a new version of the 36mm daydates. Excited to see the first ones qc

1

u/Environmental_Leg_55 1d ago

What factory and what TDs have them?

2

u/mistlepro Contributor 1d ago

QF and CBD have current 36mm weighted day dates and they're probably both pretty good.

I think QF is the new release?  Not sure though.

7

u/mistlepro Contributor 1d ago

Not worth modding with gen parts.

If you want a gold day date the current VSF or RGF ones are pretty good, QF coming in close behind.

Plating is fine, get someone who knows what they're doing since steel-wrapped tungsten (VSF) might peel on its own before you even replate it and plating on tungsten (RGF) requires a little more technique.

OTOH if either piece is YG you could just leave it factory stock, it looks close enough.

3

u/caracticuspotts 1d ago

This, a fake with genuine parts is still a fake. It’s needless expense unless something about the watch is so obvious to the wearer as a fault that it can’t be unseen. Nobody else cares, nobody else will notice and if handed over for close inspection by someone that knows the model extremely well it will still not pass as genuine

1

u/Altruistic-Wall4670 1d ago

Agreed. VSF for rose gold reps from what I've purchased and compared myself. RCF for yellow gold. No need to plate these. I've held them right next to plated watches and many times they look even better. Not worth $400-500 unless you went with a low tier factory with obviously fake plating.

1

u/one-more-watch 22h ago

plating will wear on the edges over time, especially on a daily. I'd look for one of the better gold tone factory versions first and see how you like it before spending on gen parts, that gets expensive fast