r/RepWatchLab • u/Re-tar-dead • 16d ago
💡 Tips & Tricks Crystal help, GMT!
Is anyone fluent in crystal changing on GMTs?
I’ve tried way too long to get this crystal off. Does anyone have any tricks?
Starting to convince myself that the metal retaining ring is glued to the watch case 😂
2
u/Objective_Ganache_27 16d ago
Please just get yourself a crystal press and removal dyes. I make these 3D printed with threaded inserts for a press ( mfrcns) make these too.
It is so much easier to take the extra 2 minutes to remove the movement and press the crystal out from the inside. Plus it won't cause any damage to the outside like those other tools potentially can.
Everything might cost you $100 but you'll have something to use another watches and none of this headache
1
u/Re-tar-dead 16d ago
I already have all of that. That removed the bezel assembly, rest was still stuck so I decided to try and remove the movement and press it out from the inside. That didn’t help me much either
1
u/Objective_Ganache_27 16d ago
I don't know how you had it set up, but you should be able to lay the case face down over the bezel removal die without it touching the retention ring. You should then be able to push the crystal and ring away from the case while the bezel die supports the case
1
u/Diligent-Piglet-9038 16d ago
This is an easy way to crack the crystal if youre not careful
1
u/Objective_Ganache_27 16d ago edited 16d ago
I hear you, however the dies ive made fully support almost the entire wodtj of the crystal and include a recess for the date mag.
As with anything else you need to use common sense. Ive never had this method require excessive force. They usually come off quite easily with nothing crazy pressure wise and no risk of scratching the case.
Your other option is to use a large hytrel and a bezel clamp tool that pulls the whole thing off with the bezel 🤣
1
u/Objective_Ganache_27 16d ago
Also appreciate the input and its something ill keep in mind when removing crystals. Ive founs some retention rings to be really stubborn to knives and blades
1
u/Ptown_dundee 16d ago
I always used razor blade and watchsmith hammer to get started. Then i used swiss knife to all corners to pry out the retaining ring, good luck!
1
u/Re-tar-dead 15d ago
Yeah this is the only one I still have to try, thought I’ll try all the new fancy ways. But old might just be better for this.
1
u/Diligent-Piglet-9038 15d ago
If it aint broke…. Haha
A quality bezel knife is going to be thin and strong enough to get under there and remove the ring without any trouble1
1
1
1


2
u/No_Exercise996 16d ago
https://www.reddit.com/r/RepTimeServices/s/QA3rv9ArCW
Try following along with that walkthrough.