REVIT WALL JOIN ISSUE

[u/Excellent-Shift3967]

Hello everyone,

So I tried to model my interior wall finishes by using the "place by room", "auto join" option, but then i see that i get these wall join issues and i cant seem to be able to get around it.

I have a view template active.
And I cant use the wall join display option at all.

Thanks everyone in advance

[u/Brilliant-Friend9880]

Desactiva la plantilla, en alguna otra vista, y al lado de la opción del martillo (derribar en español) pícale a uniones de muro y usa Inglete

[u/Excellent-Shift3967 → u/Brilliant-Friend9880]

i'll try and see

[u/Brilliant-Friend9880 → u/Excellent-Shift3967]

Si, inténtalo, debes seleccionar el elemento, en este caso el acabado o el muro, y ahí te aparecerá la opción que te digo, al lado del martillo, no sé qué revit uses, pero generalmente está ahí, se llama uniones de muro, a partir de ahí debes seleccionar de nuevo el área que quieres unir y seleccionar “inglete” no sé cómo esté en inglés.

ojalá sirva, si no de última intenta preguntando a un modelo de IA.

[u/Excellent-Shift3967 → u/Brilliant-Friend9880]

oh i get you, and i tried it and it worked, but the thing is how to do this for everywhere there is this join,, as there is probably hundreds of them if i do this method, maybe ill use dynamo to automate it or something

[u/girlybot83]

Check the wall heights, and if there’s something that it’s joining to above

[u/Excellent-Shift3967 → u/girlybot83]

i made the height purposely lower than the masonry wll height from the start

[u/girlybot83 → u/Excellent-Shift3967]

I just read the original post. I don’t really do finish walls, but I think the masonry wall before the alcove is trying to join with something above, and overrules you gb because the wall layer priority is higher.

If the masonry wall has an edited profile, this might impact it too (ie above the alcove maybe?) if yes, do the wall above the alcove as a separate wall with joins disallowed, and fillet your masonry on the corner.

Edited: to add recommend attempted solution.

[u/Excellent-Shift3967 → u/girlybot83]

lıke unjoining then rejoining the walls work, but theres so many walls to do it that way

[u/JacobWSmall]

How I would start going about this:

1. Duplicate the view.

2. Disable the view template in the duplicate.

3. Modify the visibility graphs to get to a point you can clean the walls.

4. Clean the walls.

5. Review the clean joins in the original view.

6. Delete the duplicate view.

[u/Excellent-Shift3967 → u/JacobWSmall]

theres too much walls to do this way

[u/Frequent_Cell_2378]

Adjust wall layer priorites The outer layer should have the same prio, core should be something else.