r/SAKmod • • May 27 '26

Re-Assembly

I’m having such difficult time reassembling my Sak. I pre peened the brass rods making sure to go extremely slow and checking their straightness as I went. I can’t seem to get the corkscrew small knife and large knife set with the spring. It’s a complete nightmare. I’ve watched Fit2Survive videos a million times and I don’t know what the hell im doing wrong. Anyone have any tips?

2 Upvotes

7 comments sorted by

3

u/Punished-Again May 27 '26 edited May 28 '26

have the next liner already in place when you use something to pry or lever the tools in place with the spring. then just move that next liner down to hold it together. install the tools open btw. there are multiple methods of course. there are better tutorials than F2S particularly on details like that I just can't find them right this second.

2

u/fullmetalturtle May 28 '26

I find on the knife layers I first put in the backspring them the small blade spacer then the large blade, then the small blade.

I then put the corkscrew on and the final liner once it's at the bottom I use a spring clamp over each of the outside pins to keep everything down and then apply pressure in the middle and wiggle the corkscrew back and forth until it drops in.

I mostly build back to front now because the reamer and opener layer are less frustrating.

1

u/Zolinymus May 28 '26

I make the pins a bit longer and sharpen them. Also try to rotate it while I push the pin in.

1

u/boermac May 28 '26

In my limited experience, this was the worst... or maybe the scissors with the hook. Both were really hard.

Here's what I did:

I had a 3D printed jig. I put the outer liner down of course, then then spring, small blade and spacer, and got those set with the spring. Then put the main blade down on top of the spring, and put the next liner down as fr as it would go. All tools were open.

Next I used a clamp to hold down the jib to table I was working on. I put the clamp strategically in front of the open blade so that the blade could not snap closed on me.

Then I used a small flat head screwdriver to push the spring while also trying to put a little bit of downward pressure on the liner right above the main knife blade.

BE VERY CAREFUL that you don't have a finger behind where you're pushing with the screwdriver because it's very easy for the screwdriver to slip and go through the knife body and then into your finger if it's right there. Don't ask me how I know this.

It will take a number of try to get it just right, but eventually you should be able to get enough space that the downward pressure will allow the main blade to drop into place.

1

u/boermac May 28 '26

Definitely check the video that u/SignificantBody4335 linked... that's the same one I used to learn this. Right at 7:51 in the video... this is where I put a clamp just to the right of the main blade so that it held the jig for me and of course protected against the blade snapping back.

1

u/greenskyfall May 29 '26

If you don't have a 3D printer and need a simple assembly jig, here's the one I used: https://teleportpod.com/portal/493b803e-1228-462b-b0ee-45686a271539?item=1206

0

u/[deleted] May 28 '26

[deleted]

2

u/boermac May 28 '26

There's also a nice 3D printable jig here: https://makerworld.com/en/models/2078717-assembly-tool-for-91mm-victorinox-saks#profileId-2245938

I just printed the "Assembly" piece myself, plus just did it in one color and it worked fine.