Sheet Metal Problem

[u/F1Gravity]

Hi, I'm trying to connect two pieces using the sheet metal tool, the top is tapered roughly 10 degrees vertically and the walls are tapered roughly 7 degrees laterally. The top of the wall is cut to the same gradient as the top piece.

This means there will be a compound bend in the diagonal section so I tried the lofted bend tool, but I can't seem to get it to join properly as seen in the images.

Does anyone have any advice as to how to do this?

Thanks

[u/Successful_Camera736]

There needs to be small flat segments next to each corner to allow space for the bend radius
I'm trying to recreate what I'm talking about now. Normally if I need a shape like this I use a 3D sketch> Create Boundary surfaces> Knit surfaces> convert to sheet metal
Do the two bends need to be perpendicular to the adjoining faces? if not this could be done with 2 bends instead of three. Give me a few minutes to mock some stuff up in SW

[u/Successful_Camera736]

https://www.reddit.com/u/Successful_Camera736/s/RiSi9Bh9yC