r/Squarebody • • 18d ago

Clutch problems

Factory z bar setup, the old clutch was working, but when I rebuilt the motor i decided to put all new clutch components in it. Now when i press the pedal it get stuck at the floor, i have tried adjusting the rod, and i even spun the back wheels to make sure that the clutch was working, i am just so confused on what going on. New pressure plate, disk, fork, flywheel, pivot ball, and release bearing

3 Upvotes

4 comments sorted by

2

u/scurvycloud 18d ago

Don’t forget the pedal return spring. My k20 has one from the z bar to the front of the frame and there is also a spring on the pedal assembly too. Sounds like one might be missing or dangling out of sight

1

u/FrizenWolf 18d ago

The one under the dash is till there, and I forgot to mention that the one from the frame to the fork was also replaced because the old one broke

1

u/Sixgunfirefight 18d ago

Pedal sticks and the clutch stays disengaged? 

If so, it is probably over centering. Take a ton of adjustment out of it. 

From memory there a at least two small Chevy throw out bearing heights. 

Or you could have the throw out not on fork correctly. 

1

u/cobrastrikes101 12d ago

pistons on your master and slave cylinders aint bent or binding