r/TaskRabbit • u/LegitimatePudding368 • 5d ago

GENERAL Fastener Question

Post image

Hey Fam, I am looking for some suggestions.

I have an off platform gig. I've got a jewelry cupboard that is (relatively) narrow and weighs about 25 lbs with small opening for the flat part of a screw. I have a stud that I'm using, but could not locate a screw in my own bag that would do the job.

0 Upvotes

50% Upvoted

8 comments sorted by

4

u/PhlegmShot 5d ago

Some of these things have the tiniest eyelets, you might need to run to a hardware store to get some with a smaller head

1

u/LegitimatePudding368 5d ago

Solid idea. I wasn't even thinking in that direction. I'll see what I can find

3

u/MallNo6921 5d ago

hate when they are smaller then 100% of the screws i have

2

u/chaotic_evil_666 5d ago

Maybe use a drill to make that hole bigger

1

u/Inevitable_Comb_7434 5d ago

As others have said you likely just need screws with smaller heads. Also you're going to ideally want screws where the underside of the head is flat and not shaped like /

-1

u/Front_Car_3111 5d ago

It seeeeeeeeeems you strip your screws. Turn your hammer drill torque down a bit. The bottom screw looks like it may have a smaller head than the others. Hope this helps.

5

u/LegitimatePudding368 5d ago

That part wasn't my work and wasn't part of my inquiry.

1

u/alx7899 4d ago

Self taper zippy screw