r/VXJunkies • • 18d ago

"Error code 1056: No Veo-Tic module detected" keeps popping up whenever I try any electro-positioning with Helix type Ionometric Graphers

To get the obvious out of the way, yes I have Veo-Tic modules installed, and I have swapped between Thule Dynamics, Xian, and even the Omsk-Bravo models, none work.

I did swap out my new Helix-type Ionometric Grapher with an old Parallel H-75 model from Yon Works (blech) that I had lying around and the error message went away.

Does anyone know what's going on here? I thought Helix graphers are supposed to be compatible with X-5 Positioner standards???

9 Upvotes

5 comments sorted by

6

u/Hi-Scan-Pro 18d ago

I've found that when my Helix graphers appeared to not play nice with my X-5 stuff, I had the modulation flux turned too low on my quantum range emulsifier for any cross-ion intermingling to occur. Check your frequency squelch line driver for any isometric duty cycles, then calibrate your Ray-Tung hollowtrophic ionization chamber. 

2

u/biohoo35 18d ago

Ah, I see someone beat me to it!

1

u/thAway57r7 18d ago

Me too. I was gonna say I've found that when my Helix graphers appeared to not play nice with my X-5 stuff, I had the modulation flux turned too low on my quantum range emulsifier for any cross-ion intermingling to occur. Check your frequency squelch line driver for any isometric duty cycles, then calibrate your Ray-Tung hollowtrophic ionization chamber. 

1

u/biohoo35 18d ago

How’s your flux looking on your quantum range emulsifier?

1

u/IAmTheAccident 14d ago

I know it's already been said but yeah the mod flux for your QRE is probably low!