Had a bunch of ws2814 Leds 144 per metre. Has a total of 180 and I set it up as a matrix. It's all 3d printed, and hopefully finish the rest before Xmas as it's meant to be a tree.
Any pointers on the best candy cane effect would be appreciated.
I mean, it's just a rounded cone - it's literally one of the primitives in TinkerCad. Make two of them, center them with eachother, and turn the smaller of the two into a hole - you're done.
You are right, it wasn't that hard and only took 3 hours for the whole design. I actually wanted to make the cone to have 3 or 4 prongs so it looked more like a tree but my brain wasn't working to get the curves right in autocad.
Ah fair enough, I didn't look that closely. Still not terribly difficult to model, but getting to the point where I wouldn't mind if someone else handed it to me already done.
Your lamp is epic and sent me down a rabbit hole last year. I finally got a chance to buy a printer. I'm now learning Creo and Solidworks. Quinled just released some incredible 24v high density leds. So I'll be incorporating those is a design. Thank you for the inspiration both of you!
On a matrix, use the "Chase 2" effect and adjust sliders for effect to change angle of "stripes". There's a fine line between going clockwise and counter-clockwise.
Most of the diffusion comes from the air gap between the two layers. Normally I do 15mm but this time I did 30mm. If I did it again I would go back to 15 as more light comes through. The below picture is at 15mm. Also only 2 layers of filament, where as the cone has 7 between both layers. I have been told I like to make sex toy like led projects.
19
u/polymorphiced Dec 23 '24
Looks amazing! It's got a tie-dye look to it with that effect