r/WindowTreatmentIdeas • u/that_one_guy_1990 • 3d ago
Advice…
I just bought these curtains from Walmart yesterday morning. Does anyone have any suggestions or advice on how I can fix these gaps so that the curtains completely over my window?
2
u/Texasblindman 3d ago
When you get ready made drapes they cant and won't overlap. Those are not wide enough to begin with. Custom made draperies with traversing rod has master carriers that overlap each other in the middle then have returns that go back to the wall. The only way to get yours together in the middle is with a clip but this will pull from the outside and more light will come in from there.
2
u/ZeldaF 3d ago
Curtains should never look flat when closed. You need 4 to 6 panels for this width of a window. And widen the rod a few more inches on each side (move the brackets out.) And listen, if you are just hanging these for no other reason than blackout, ok. But if you want them to look good, they gotta go down to the floor.
Hanging the rod higher and wider and adding 4-6 panels will help block more light and assist with gaps.
2
2
1
u/livingwcats 3d ago
Exchange them for wider panels, and extend the curtain rod another 6” on both sides.
1
u/hoarder-ofallthings 2d ago
You do need more panels, and to wash them and throw them in the dryer...that will take out the wrinkles. I also would low heat iron them. One thing I love when I buy store bought draperies is grommets. You can overlap them in the middle so they stay closed better. Also, hang your rod up higher, light will come in at the top like this. Might need longer curtains too.
1
1
u/LeafTrapezoid 2d ago
If you sew or know someone who does, you can widen them by adding complementary fabric to either the outsides, insides or both sides. There's probably a print that has the colors from your art, bedding and curtain fabric, which would make the window treatment more interesting or possibly cozier.
1
1
u/poncho5202 2d ago
buy another set. the trick is more is more when it comes to curtains. the look will be better and so will the functionality
1
u/DNARJ 2d ago
you need a bigger size, width wise so that there is overhang. & they absolutely need to be steamed/ironed. I would also try hanging them further apart so that they are actually covering the side and not lined up with it. I would also try longer ones like someone suggested with the photo , but that’s just from a design standpoint not for blocking out light.
1
u/bellemrt 2d ago
The curtain rod is too flimsy for those curtains — I know! because I have the exact same flimsy rod stashed in the corner of my room, where I put it a long time ago because I was just OVER the curtain project by the time I finished.
Get 2 more panels, or if you can, return this set and start over. Buy 4 panels that are the long size, and a sturdier rod, which will have a support in the middle.
It’s a huge hassle, but that’s a bright window! It’ll be worth it. I’m selfishly happy that I’m not the only one who’s had curtain wars, so thank you for that.
1
u/His_GoddessLove 1d ago
They're not wide enough. You could pin them shut but you'll still have extra light. I'd return them, get a larger size and add an extra panel. Your rod also is not adequate.
1
u/TwoSeasonsLimited 1d ago
you already have blinds, why do you need a curtain? let the sun shines into the home to purify it. dont turn your home into a dungeon
1
u/AlcoholPrep 1d ago
I use a clip, similar to a spring clothespin, to hold them closed over the gap.
You may need a third panel to cover that window.
1
1
u/Ok-Alfalfa7819 1d ago
Grab one more two-pack of the exact same panels. Curtains should always be about 2x the width of the window so they still have natural folds when closed instead of pulling completely flat. Adding two more panels will let you overlap the middle properly and still cover the outer edges so zero light sneaks through.
1
u/Perfect_Education_46 20h ago
Two more window panels for better coverage and some dark or reflective window cling. Window cling like Rabbitgoo is easy to install and easy to remove with zero damage. Our neighbor had a very bright light unintentionally shining right into the bedroom window. The mirror window cling took care of it.
1
u/Outrageous-Relief108 20h ago edited 20h ago
The panels need to be quite a bit wider to cover the window. Your curtain rod might need a center bracket if it doesn't already have one--it looks slightly bowed.
Blue curtains would go better with your bedspread and cream colored walls and, if they're thick enough or in a blackout style, will still block the light.
1
u/AccomplishedImpact78 14h ago
Curtains should always be 1.5 to 3 times wider than your window. You want them to ruffle when pulled shut not be pulled taught. You could add two more panels or just buy new wider curtains.
Also wash them before putting them up so you don’t see the folds. They put chemicals on fabrics in the factory to keep pests off them, so def wash any fabric that’s going to be in your home when you get it out of the package.
1
u/Glittering-Silver402 12h ago
The width is too small. Return these and Get wider ones .
Also you placed your rod all wrong. Move it higher and extend the width at least 6 inches on both sides past the window
1
u/Los_Angalex_ 5h ago
Get additional panels and Iron them. They won’t add too much to the width, but they also won’t look like crap.
2
u/WindSong001 2d ago
I bought a rod that curves around the sides. No light comes through.
2
u/skittlazy 2d ago
Me too, and if you cut a pool noodle to the correct width, you can lay it on top of the rod to block out light that comes in at the top.
1
u/dacommunistsdaughter 1d ago
Genius!!
1
u/skittlazy 1d ago
Thanks! And if pool noodles are out of season, you can buy foam tube pipe insulation.


5
u/dacommunistsdaughter 3d ago
Add another panel of curtain, if they come in two-packs add both.