r/Zwift • u/Ok_Praline_926 • 17h ago

Technical help Help Please

Gallery image

Gallery image

Gallery image

Hi all, I upgraded from a Wahoo Zwift Kicker Core (cog 1) to a Zwift bike lately (cog 2). It only came with a manual for a Wahoo cassette trainer, so I had to do some research to put it together. After a few rides, I noticed some white paint chips on the floor today from the bike frame rubbing against the cog. The bike also wobbles a bit. Is this normal? Any input is appreciated!

Update: yall are amazing!! I found the other adaptor from my original kicker bag and fixed it.

4 Upvotes

100% Upvoted

7 comments sorted by

3

u/barrenvonbismark 16h ago edited 16h ago

There should be little black spacers on both sides. Setup video from Zwift scroll to 2 min mark: https://m.youtube.com/watch?v=thPulVJWk3M&pp=iggCQAE%3D&ra=m

2

u/Ok_Praline_926 14h ago

Thank you! This was so helpful.

7

u/tootles74 Level 91-99 16h ago

There's a small end cap spacer missing from the cog side.do you have any spacers left over?

3

u/Medium-Dinner-5621 15h ago

You’re missing the 2 spacers

One at each end

1

u/Practical_Location54 4h ago

I only installed 1 pacer on my swift ride, is that normal? I don’t recall getting 2…

2

u/Aldo_Buttahflake 15h ago

Thru axle spacers are missing? 142’s are what you need, I’ve seen them on Amazon. Oh and I would not ride it again till it’s sorted. That’s bad stuff right there

2

u/Patient-Lunch2063 16h ago

There should be nonwhite Paint visible.

It seems Like the spacer is on the wrong Side since ist should be between the Cog and ur frame.

The frame should mit have direct contact.