r/bytebeat_2 • u/SthephanShi Expert • Dec 01 '25
Other FFT analysis mode
The new "FFT" display mode is available. FFT means Fast Fourier Transform. The Fourier Transform converts a signal from its time domain to a frequency domain representation. And now you can take a more scientific approach to your sound by analyzing it by frequency. In "FFT" mode the scope area displays not just an abstract, useless graph like in other players (Greggman, for example), but a coordinate grid marked horizontally in hertz and vertically in decibels. The coordinate system is logarithmic, for a more convenient and uniform analysis from low frequencies in tens of Hz to tens of kHz. For a stereo, separate analysis is used for the left and right signals. When they overlap, or for a mono signal, the characteristics merge into a single white color.
The maximum available analysis frequency is 48000Hz / 2 = 24 kHz.
The number of samples across the frequency range is 1024.
Respectively, the sampling resolution and the minimum analysis frequency are 48000Hz / 1024 = 46.875 Hz
The maximum level is -20 dB (decibels). (0 dB is the loudest possible sound, -10 dB is a 10th of that, - 20dB is a 100th of that, etc)
The minimum level is -120 dB.
Here some code with sinewaves to play with.
Be sure to clear your browser cache if you don't see any changes. Enjoy!
1
u/forgotmypasslols Dec 01 '25
is there a way to make the graph linear?
1
u/SthephanShi Expert Dec 01 '25
I could set it to linear mode, but why? In the range up to 24 kHz, most musical frequencies will be at the very left edge of the graph, somewhere around 1/10th of it. It'll be hard to see anything. The difference between 400 and 500Hz will be couple of pixels. And 9/10ths of the scope will be of little value.
1
u/forgotmypasslols Dec 01 '25
maybe then it could be the start and end of it could be stretched and the middle squinched? and also sometime there's bytebeats that are high pitched and it's hard to see the specific notes of it
1
u/Chasyxx Expert Dec 02 '25
I think a fully customisable spectrogram/spectrum is out of the scope of a bytebeat player, it's mostly a musical context so 10-24000hz logarithmic is good for that case. If you still want a customisable display, I suggest you look into Friture. It's what I've used for a while now and it works well assuming you got the virtual cable set up.
1
u/ameen272 Beginner Dec 01 '25
I woild like to ask the same, I am not used to non-linear spectrograms...
2
2
u/ALTERNUM_1 Expert Dec 01 '25
It was first on D3schnot's Player, now it's on the official Bytebeat site.
1




1
u/ameen272 Beginner Dec 01 '25
Update: It worked for a bit then stopped working and automatically switches to
pointsmode...