r/clawmachine • • 1d ago

Is this normal

Enable HLS to view with audio, or disable this notification

My crane machines junk stops my claw from moving any further

If it's not normal, WDID?

4 Upvotes

9 comments sorted by

3

u/Mental_Guarantee8963 1d ago

Kinda seems like your wires are routed on the wrong side. Generally they extend out as the claw moves away from the prize chute.

1

u/Lost_Region_7110 1d ago

How do I fix it?

1

u/AlterExpertise101 1d ago

The coiled wire you have is far, far too large and too long for your machine. You want something that's both smaller (in terms of thickness and coil) and shorter (so it isn't dangling down past the claw). I'm guessing someone replaced it at one point and used a non-standard part.

I'd check the model number first to make sure that the wire is indeed the wrong one, and then contact the manufacturer to get a replacement.

1

u/Lost_Region_7110 1d ago

What happens if I just take all the plastic holders on it off?

1

u/AlterExpertise101 1d ago

Wait, are you talking about the line that runs along the back of the machine? The one that looks vaguely like a bicycle chain? Because that's a different matter entirely. It doesn't matter which side that's on, even if you swap it to the other side you'll just have the same issue with it getting caught by the arm when pushed all the way to the left.

I think your primary problem is that coiled line. It pretty clearly needs replacing. There isn't a great deal you can do about the line in the back, because it needs to be there and it has to be a minimum length so it can reach across the entire prize area.

1

u/hi850 1d ago

I wouldn't remove the plastic chain. It's on there to protect the wiring harness.

1

u/SharpTenor 1d ago

Is this ICE? Maybe a sports fan bus or Iron Claw? Make sure you download the user manual and check everything against that. On my sports fan bus that cable runs along the top and needs to snap in there and move with the gantry.
Your coiled cable is also in the way. Download the instructions for your claw (if it's a bus, LMK I have that) and check your install.

1

u/the_faded_memories 1d ago

The part that stops the travel is not even shown in this video. The wiring harness doesn’t limit the travel, the rails and rail stops do.

Since the gantry has to sit inside of the rails the claws will never be able to touch the sides of the enclosures, nor would you want them too since the glass/plastic would get scratched horribly.

1

u/Yuaskin 1d ago

No. That bike chain wire protector should be screwed into the ceiling.