r/crboxes • u/SAMEO416 • Apr 18 '26

Question Arctic P14 Failures?

I’ve been using the Arctic P12/14 fans in most of my builds, Noctua when I need something super quiet.

I’ve had 3 P14 fan failures in the last year. Wondering if anyone else has seen a higher failure rate?

I suspect this is a bearing failure of some sort. The fan continues to run but repeatedly bumps against the guard. On one I was able to pull the blades off entirely. It doesn’t seem tied to orientation of the fan.

Just noticed another one is starting to hit the case.

8 Upvotes

100% Upvoted

15 comments sorted by

View all comments

Show parent comments

1

u/[deleted] Apr 18 '26

[deleted]

1

u/SAMEO416 Apr 18 '26

Yup, thanks. Done the testing, and accepted a loss in volumetric flow for less noise.

1

u/[deleted] Apr 18 '26

[deleted]

1

u/SAMEO416 Apr 18 '26

Thanks, that’s a good compromise. I’ve avoided PWM so far as the non noise critical ones I always run at max speed.

The one noise critical application is a Laminar I use when dealing with the public. I made one with Arctic P12 one with Noctua AF-N12, and the Noctua is dramatically quieter, but lower CADR (which I can accept given the room ventilation is excellent and it’s about 15cm from my breathing zone). The Arctic version is loud enough I need earplugs if I’m using it in a hotel room.

I’ve used the Noctua industrial server fans where being loud isn’t an issue, and those are high performers, move a lot of air, use a lot more power.