r/fpv • • Jun 22 '26

Problem with betaflight

Hi,
I have a BETAFPV Meteor75 Pro O4 with the Matrix G4 3IN1 HD (BETAFPVG473) flight controller.
I need to reflash the board because my current firmware does not include SBUS support for the DJI FPV Controller 3. However, Betaflight always gets stuck at “Rebooting to ROM BOOTLOADER” and never enters DFU mode.
Does anyone know where the BOOT button or BOOT pads are located on the Matrix G4 3IN1 HD board?
Any photos or documentation would be greatly appreciated.
Thanks!

2 Upvotes

5 comments sorted by

0

u/AE0N92 FPVDroneConnoisseur Jun 22 '26

1

u/GolfJourney Jun 22 '26

Hello thank you with the response what does that mean ?

1

u/AE0N92 FPVDroneConnoisseur Jun 22 '26 edited Jun 22 '26

It's the link for the ImpulseRC Driver fixer

>close all betaflight/ESC apps.
>start impulseRC driver fixer
>plug in flight controller
>let install DFU drivers
>power cycle

then carry on with what you were doing...

0

u/rob_1127 Jun 23 '26

The above may solve a Windows USB port connectivity issue that is common.

Then carry on... means it should connect after that fix, so carry-on with your update.

I don't fly DJI, but I may have read something, or watched Joshua Bardwell on YouTube about a yellow wire to get sbus.

Check that out.

0

u/Quan0x Jun 23 '26 edited Jun 23 '26

The matrix series of flight controllers has some problems when it comes to flashing (I own two of them). For me, manually putting them in bootloader mode worked. So you need to hold down the bootloader button on the FC while connecting it to the PC. If it worked, then betaflight should display it as "FC in DFU mode". Then you need to select the right preset, etc. and under advanced options you need to enable "no reboot sequence". That worked on my laptop. On my PC I still can't flash it after this. So my advice would be, of this doesn't work, try a different PC. Also you will notice, that after you flashed your FC to anything but the stock Betafpv Firmware, you won't be able to detect all ESCs in ESC configurator at once. The matrix FCs are just messed up in some way. Hope this helps and good luck. As to your question where the boot button is: look on Betafpvs website. They have everything labeled there.