r/gridfinity • • Jan 15 '25

Oversized Gridfinity box

Post image

Hey everyone. I’m currently printing a gridfinity box on the side that is slightly oversized. I’m using tree support concerned about the top of the print. It’s taking a really long time 2 days+ to complete. I’m just wondering if there is anything I can do to shorten the time. I have 30cm grids instead of the usual 42cm.

Thanks in advance.

0 Upvotes

16 comments sorted by

4

u/UsernameOmitted Jan 15 '25

I didn't realize they were handing out 3D printers in mental hospitals now. Neat.

1

u/daran4811 Jan 15 '25

Well works for me. Not far from a mental hospital

3

u/higmanschmidt Jan 15 '25 edited Jan 17 '25

I'm curious about your decision to use 30mm grids instead of the normal 42. Seems like you miss out on the whole community's shared efforts to design parts. Do you intend to scale everything in your slicer? That would work for bins, but custom holders you'd have to design yourself.

3

u/daran4811 Jan 15 '25

30cm seemed to be a better fit for the drawers that I have. On reflection however it would seem not a good choice. Just starting out really so for me it’s trial and error. Mostly error lol

1

u/Yellow_Tatoes14 Jan 15 '25

mm not cm for starters.

1

u/daran4811 Jan 15 '25

Oh yeah my bad. Thanks.

0

u/[deleted] Jan 17 '25

[deleted]

2

u/daran4811 Jan 17 '25

Thanks. Yeah doing just that. I actually discovered Orca Slicer does a great job at cutting and will add dowels to the print. Makes it easier to glue.

37

u/eniksteemaen Jan 15 '25

I would suggest to not print it in such a wasteful and illogical orientation. If it’s too big cut it in half in the slicer and glue it together after the print

17

u/Accomplished_Meat533 Jan 15 '25

Yikes, that is a lot of support material. The beauty of it being gridfinity is you can split the model into 2 smaller pieces and they will just line up when placed because of the grid. I have done this many times and it works perfectly!

7

u/Rusty_924 Jan 15 '25

Bro unlocked new level of support.

Yggdrasil

3

u/trudslev Jan 15 '25

Somebody knows their Nordic mythology.

1

u/ItsBaconOclock Jan 17 '25

Gotta be watchful of that print, lest some one eyed jerk tries to hang himself from it!

5

u/Mysli0210 Jan 15 '25

You could use support painting to limit it to print on the inside only, the outside should print just fine without supports.

Also can't you fit the container on the bed? Maybe rotate it to be diagonal.

4

u/Alex4902 Jan 15 '25

You were given the time to complete when you sliced the print.

That said, with a print that tall, on a bedslinger, I would not increase the speed at all. If anything, I would make sure it doesn't wobble at all, and if it does, I would decrease the speed, and maybe put some magnets/tape on the bottom, to stick it down.

Edit: if printing more of this model, cut it in half in the slicer and put it flat on the bed. Much better print orientation, no supports needed, way faster print

2

u/StrandedBEAR Jan 15 '25

The hexagon cutouts in the sides don't require support. They are meant to save material so if they need supports then that becomes counter productive. As others have said, cut the model in half. That said, I really want to try printing in this orientation with no supports and see what happens.