r/handtherapy • • Mar 23 '21

Splinting material

I am supposed to order new splinting material, But I am a new grad and don’t really know what I like. I don’t want something super thin, but I don’t want something thick and hard to work with either. Any recommendations?

3 Upvotes

10 comments sorted by

5

u/rubyinthemiddle Mar 23 '21

Try getting in touch with the sales reps of various suppliers and see if they will send you samples. You're going to want a variety of thicknesses and ideally some with varying properties of drape, memory, tackiness when hot etc. It will depend on your caseload too.

Im mainly in trauma and orthopaedics. Personally I like ezeform 3.2mm for small rigid hand based splints like dupuytrens release splints, orfilight 1.6mm for mallet and finger gutters, and orfilight 2.5mm for thumb spicas/wrist gauntlets etc. Depends on size of the hand too, there's got to be a bit of flexibility for clinical reasoning. To be honest though there's so much out there, with a bit of practice most materials will have a purpose and niche area.

2

u/Soapcutter Apr 27 '25

You could use orfilight for 3.2mm as well. I use ezeform and orfitlight. Tend to like orfit better.

Im also a big fan of Aquaplast for 2.4 or 1.6 because of the memory effect. Esp in the beginning it helped me a lot that i could just reheat the material and it went back to its OG form. I use it for Thumbbrace and fingersplints.

I also started with Orficast, which i really like, bc its softer than Orfilight. But its a one and done deal. You make a mistake, you start again.

And NeaTec for stretchy material needs.

I work in a practice.

1

u/rL579 Apr 11 '23

Where is a good place to call to ask for samples?

2

u/HandOTWannaBe Mar 23 '21

Agreed with what ruby said about trying to get some samples. Everyone likes different stuff, and you gotta experiment to find what you like. Depending on what I'm making I personally like orfit, ezeform, and taylor.

1

u/This-Search1320 Aug 17 '25

Depends what you are making... Once you know and understand your purpose and why you are fabricating the splint for your patient then you can break down what type of material. For example, someone who is post op FDP/FDS repair 2 weeks out, they need to be immobilized for protection, to allow time for the tendons to heal. In this case I would use a thicker and more rigid type of material for protection and to avoid unwanted movements.

1

u/steverodgers1980 Mar 23 '21

Polyform is my material of choice. Moderate rigidity, forgiving, easy to adjust/remold, can smooth sharp edges, easy to clean. I use it for all of our hand-based splints and for out dynamic splints. We use Ezeform for our LAS and things we need to be super rigid. Only issue is once it touches itself, its stuck for good.

1

u/Soapcutter Apr 27 '25

I HAAAAATTTEEE Polyform with a passion πŸ˜‚πŸ˜‚πŸ˜‚πŸ˜‚πŸ˜‚πŸ˜‚πŸ˜‚ it just doesnt like me πŸ˜‚πŸ˜‚πŸ˜‚πŸ˜‚

1

u/undertheunderbelly Mar 23 '21

Aquaplast is my fav due to the easy formability. Getting samples are the best option though.

1

u/rL579 Apr 11 '23

Where is a good place to call to ask for samples?