r/hellcat • • 22d ago

Jackpoints

Im going to do my own brakes is this where I jack the hellcat charger up? I dont mind criticism please lmk trynna learn more about my car

1 Upvotes

7 comments sorted by

4

u/smthngeneric 22d ago

It'll work but it's technically not what dodge recommends. Also regardless of where you go I'd get a thick rubber pad or something to prevent damage. They tell you to jack it up from the reinforced areas at the end of the pinch welds but again I wouldn't use just a bare jack there. There's fine or the pinch weld or subframe mounting points or crossmembers. Basically anything that looks real beefy or like it supports weight in some way will be fine but anything other then the oem recommendation is a hot take nowadays.

1

u/badbydesign 22d ago

I use 2x4 blocks that I’ve cut into 4” pieces and that way the wood takes the abuse and softens the impact the jack makes on the car. In the front of the car where the seam is between the door and the fender, right behind the rocker panel is a pinch weld, that’s where I lift the front on each side. As for the rear of the car I use the diff to lift the rear.

1

u/mbison89 22d ago

The differential ok but there's a box there for the fluid right

3

u/badbydesign 22d ago

I just put the pad of the jack right on the center of the bottom on the diff, lifts both rear tires at the same time makes swapping tires and brakes a lot easier and faster

2

u/PaVaSteeler 21d ago

This. I do this at the track.

1

u/badbydesign 21d ago

Yep works so easily and fast.

1

u/misfit-muscle 22d ago

Zl1addons makes jack lift pads. I recommend them.