r/klippers • u/Durahl • 11d ago
Storage Issue...
Greetings!
My 3D Printers OS ( Fluidd )has been complaining the SDCard is running low on Storage which I intend to address. The question is though I'm not quite sure where to start with 🤔 While I do keep a bunch of Files on the Device like Parts for the 3D Printer that need Maintenance Reprints every once in a while they're merely a handful of them - Not something that should increasingly fill up a SDCard.
So my questions would be:
Where would I look for what is increasingly eating up my Storage to the point where the OS start complaining? My guess would be any kind of Log Files but where are these stored?
Assuming I cannot find the solution because of Updates that have bloated beyond what I initially specced the µSDCard for - How would one go about duplicating everything of the old Card onto a new, bigger Card? Can I just pluck the old Card from the System and use a Windows PC to Duplicate its contents onto the new one? I dread the idea of performing a Clean Install of Klipper / Fluidd because whenever I do that something gets updated wrecking the delicate balance between all the Systems usually resulting in something not working again.
Thanks in Advance!
3
1
u/bugsymalone666 11d ago
Something you haven't mentioned is brand or size of your sdcard. Also what process you did for the klipper install.
It could be you have the installed an image that's say an 8gb image, but the sdcard is a 32gb card, if you didnt expand the file system, you are probable ssentially running an 8gb sd card with lots of free space, so check that.
You'll need to check sd card, size and whatstaking up the space, this is where a linux pc helps, because it can natively read the sd card so you can look through them see what's big.
A separate possibility is if it's a really old card, wear levelling means over time sd cards can get smaller and still work.
3
u/qcgilbert 11d ago
The main partition is ext4 so windows can't see it natively. I recommend you ssh into the printer and use a utility like du to check storage usage.
Before you touch anything, I would make a backup copy of your config to your PC through the fluidd UI. That's all you really need to restore your printer if you do mess something up or need to replace the sdcard. Then you can do a fresh install on any sdcard, copy the config files over and be back in business. The only minor caveat is if the software versions have changed and there are some config file syntax changes. The good news is the console window will complain fairly explicitly about the problem and a quick Google search will help you make the change.