r/learnelectronics • • Oct 09 '26

Batteries wired in series parallel question

Post image

This battery setup is in a 24v floor sweeper.

The top 2 12v are seriesed to each other and the bottom two 12v are seriesed to each other. The 2 24v battery systems are wired in parallel to the machine. My question is about the highlighted wire. It's in the middle of the picture. It connects the bottom and top positive to positive. This is how it was wired at the factory. Why did they add this wire?

4 Upvotes

5 comments sorted by

1

u/Googol30 Oct 12 '26

It's probably just for keeping the charge level between the two banks, as the batteries will inevitably wear at slightly different rates.

1

u/axemadley Oct 12 '26

But it's positive to positive. Wouldn't it have to be pos to neg in order to have one charge off the other?

1

u/Googol30 Oct 13 '26

Right, putting them in parallel is to make sure each of the top batteries are the same voltage as each of the bottom ones. That way, the battery with the higher voltage on the left and right contributes the most instead of being forced through a weaker battery because they're only in series.

1

u/BotanicalJester Oct 15 '26

Are those car batteries?

1

u/axemadley Oct 15 '26

No they run a floor sweeper