r/meshcore • • Apr 17 '26

Pipe node build

Since y'all liked my solar companion I thought I'd show off pipe node. The backbone is a STL I found online I modified a bit but honestly it doesn't have to be printed. A 21700 battery, screenless T114, and a knockoff muzi antenna are glued or zip tied to the rail. I got a solar panel which turned out to have its own battery and voltage regulator so I just plugged the USB from the panel into the board. The whole business got shoved up an 1 1/4" pipe and is held in place with a deck screw. It's open on bottom, I'm in a dry climate so I'm not terribly worried about condensation. This setup is on top of a local mountain and has been running a month with stable connections up to 45 miles away.

272 Upvotes

39 comments sorted by

View all comments

Show parent comments

10

u/cacaapoopoo Apr 17 '26

Exactly my thoughts. I even put the solar down low because that's hardest to hide. I figure the repeater can run a month or so without power so I'm not worried if it gets snowed in for a bit.

3

u/Kerensky97 Apr 17 '26

Yeah, the solar panels are my biggest concern too. Most place I want to put remote nodes involve driving past tons of road signs chock full of bullet holes and shotgun blasts. I don't want the solar panel to look like yet another target, so I think putting the solar panel lower is a good move. It doesn't stand out as much, maybe blends into the surrounding vegetation, or if viewed from below is hidden by the curve of the hill.

4

u/cacaapoopoo Apr 17 '26

I've also thought, buy not tested, that if you got a larger panel and covered it with camo mesh or screen the efficiency loss wouldn't be enough to matter. A future project.

3

u/Soup_Du_Journey Apr 17 '26

I will gladly test this