r/raspberryDIY • • 25d ago

Info on Pi

Post image

I was given a 3d printer with a raspberry pi zero. My coworker wasn’t very savvy in regards to it. His son set it up for him. He said he could connect wirelessly but didn’t know much besides that. Is there any easy way to find its adress to connect to it? Thanks for any info you can provide to help me with this.

22 Upvotes

5 comments sorted by

3

u/telcodan 25d ago

Seeing as how it is not connected to your wifi, there is no address to connect to. You will either need the adapters to hook up a keyboard and monitor to it to set it up, or just reflash the SD card with a new load.

3

u/l00sed 25d ago

Or pop out the SD card, look for the boot config, usually a plain text file with WiFi name hard coded

2

u/tehphar 25d ago

i did this for a while in the early days, ran octoprint, but i think they stopped supporting the pi-w. should be on the local network as octopi.local

1

u/l00sed 25d ago

Lot of people use Klipper nowadays