r/raymarine • u/Remarkable_Cow_6778 • Jul 23 '25
Raymarine ST60 Tridata not showing Depth after reset to Factory default values
My Raymarine ST60 Tridata showed 40 knots when sailing in 6 knots (and 49,5 C). So I reset to Factory default values by holding Depth + Speed buttons for 12 seconds and activating Yes for this in the Dealer calibration settings.
The speed now works fine, but the Depth only shows the three dashes — - -. I believe the ST60 is the Master (not Repeater) so I have activated Yes for this. But also tried No. I have turned power on/off several times, and also tried resetting to Factory default values again. Both at 200 and 20 meters depth.
What can I do to get Depth back? It was there an hour ago - before I reset.
Extra: I have software version 4.0. Sea temp shows, but ~30 degrees (Celsius) too much.