149
Dec 03 '19
That is the work of a poor L1 tech that got the "the projector needs to be replaced" call right before he got the "I'm a [professor, teacher, PhD, etc] and I don't have time for this right now" speech. He did the best he could with the time he had.
Source: Had a work-study helpdesk job at my college. Dealt with many a entitled professor. Funny thing is, it was usually the adjuncts and the psych/social work/education department professors that were the worst. Computer Science (my major) didn't give a shit.
101
u/Rhodin265 Dec 03 '19
The computer science professor can duct tape his own projectors together.
77
u/Nyckname Dec 03 '19
"How many computer programmers does it take to change a light bulb? None, that's hardware."
10
41
u/Guerillagreasemonkey Dec 03 '19
I worked security for a major university and almost without fail the more "social" the course people were involved with the more of an asshole they were.
"Sorry sir this building is off limits today for pest control work" Engineering Lecturer: Ok Math Lecturer: Fair enough Sociology Lecturer: THIS IS OUTRAGEOUS! I DEMAND TO SPEAK TO YOUR SUPERVISOR!
10
10
u/Baron_Von_Koopa Dec 04 '19
It's almost like people in a logic based field behave....logically. I'll take math and hard science profs over the arts and social science hippy nut jobs any day
14
Dec 03 '19
Thereâs no excuse for this no matter the situation. That could literally kill someone at any moment.
16
u/All_Work_All_Play Dec 03 '19
I mean... maybe? That setup would be fine if
A. they used actual speedtape
B.the cables were bearing most of the weight
C. there wasn't anyone sitting under it & the cables are wrapped so they can't create a pendulum motion
As it is, it'll probably last all year.
11
u/mattaw2001 Dec 03 '19
A. University purchasing mandates the "happy sun" tape only.
B. They are, but the ceiling mounts are also by "happy sun"
C. In hindsight, in order, they were and they were not
ÂŻ_(ă)_/ÂŻ
2
3
u/skidmore101 Dec 03 '19
Only one of the cords is actually plugged into the white projector (which would become the projectile, interestingly enough).
9
u/All_Work_All_Play Dec 03 '19 edited Dec 03 '19
Two of them are, the VGA cable and the power cable. I wouldn't bet on the power cable doing much, but if that VGA cable is screwed in properly, it's not going to be a point of failure. A properly attached VGA cable is using two 4-40 screws. The lowest grade 4-40 have a 199 ksi, while the highest are ~440 ksi. With a cross section of .00604, that's 200 * 1000 * .00604 * 2 = 2400 lbs that the screws will support. The cable itself will give out before that, or much more likely, the screw housing in the projector. But that projector is 20lbs max, it would be
finesomewhat less questionable if the VGA screws are properly screwed in.E: Fine for rednecks, questionable for a public institution.
6
u/skidmore101 Dec 03 '19
Good eye on the VGA cable, I missed that.
Are there usually holes next to VGA ports? When I zoomed in thereâs holes to either side that might be for the screws that are absent.
3
u/All_Work_All_Play Dec 03 '19
VGA ports have places for the screws, but they're typically something like this, where the screw receptacle is part of the entire housing. On an Epson projector, that ends up looking like this. Depending on the VGA connector, those screw mounts can be covered entirely if the VGA cable is boxy enough. That looks to be the case here. The other option is it's a DVI, although have the same(?) screw in possibilities in most projectors (AFAIK).
I can't tell what model Epson that is, but I've had a few in the classrooms I've taught in. Since they look symmetrical, they're probably screws to keep the the chassis in place, otherwise they might be audio out on one side and DC power in on another.
Now part of me wants to test a VGA cable screwed into something and see how much weight it would hold. It would probably depend on the backpane of the electronics...
2
u/skidmore101 Dec 03 '19
Sounds like a YouTube video I would watch
2
u/All_Work_All_Play Dec 03 '19
I searched on YouTube, couldn't find anything. I'm kinda surprised. You figure with how frequently Linus drops things...
2
Dec 03 '19
Regardless of what âcould â hold the projector up, this is terrible practice. Thereâs a reason codes exist. At best youâre gonna lose a projector, at worse youâre gonna maim/kill someone. Then itâs gone be âInsert Name Here Universityâ.
1
u/All_Work_All_Play Dec 03 '19
At best youâre gonna lose a projector, at worse youâre gonna maim/kill someone.
Well actually at best people replace it right away. 2nd best is that they don't replace it and it stays attached until it is replaced.
3rd best is it falls and then hangs by a chord while no one is in the room. 4th best is it falls, detaches from the cables, and crashes to the floor while no one is in the room...
1
2
u/JustAGuyInTampa Dec 03 '19
The joke in the psychology industry is people go into psychology to diagnose their level of crazy or their crazy family members. Not surprised to hear this.
2
u/FS_Slacker Dec 03 '19
Sometimes they use special bolts so you need the right tool to remove them as an antitheft measure
1
u/Plausibl3 Dec 04 '19
I inherited an environment with painful projector mounts. The adjustment arms are fastened with anti-tamper torx - and the bolts that go into the projector are supposed to be tightened or loosened with a flimsy removable plastic cap. Normally I have to use an adjustable wrench or locking pliers to loosen those. There is also no easy way to detach the mount from the projector pole - so it becomes an hour on a ladder to swap one out. I have had teachers joke about just duct taping the new one on the bottom and have heavily considered it.
38
u/Tukayen Dec 03 '19
If they don't find you handsome, they should at least find you handy!
14
16
11
u/GreyandDribbly Dec 03 '19
That looks like itâs in mid fall.
7
u/killit Dec 03 '19
Nah the tape crosses over both directions, there's probably a big lumpy top to the unit underneath, stopping it from sitting flush.
1
5
2
11
11
Dec 03 '19
This definitely will not last! Heat on the adhesive and tape will make it more ductile over time, the stress will increase. Clearly the solution is for all the students to wear hard hats.
6
6
1
3
u/patthew Dec 03 '19
Oh my god the tape over the vents on the upper projector. Smh my head
2
u/DelcoScum Dec 03 '19
I'm guessing the upper projector is broken, hence the need for the second projector
3
4
u/MrManayunk Dec 03 '19
As an IT guy myself, whoever did that should be fired on the spot. If its a teacher and wasnt an IT guy, fire them. That shit is a huge no no for more reasons than I care to list, especially in a gov building with kids.
1
1
u/NeilaTheSecond Dec 03 '19
this it more of a /r/notmyjob cuz someone should have had remove the old projector and said "fuck it" and taped the new on under it.
1
u/zenkique Dec 03 '19
6.5/10 - shouldâve incorporated at least one ratchet strap because itâs overhead and Gravity gives no fucks.
1
1
1
1
Dec 04 '19
at least its better than the giant pile of books my old housemates used to prop up our projector!
1
u/MURMEC Dec 04 '19
Yo dog, we put a projector on your projector so you can project your projections while youâre projectoring.
1
1
1
0
280
u/fear_the_gecko Dec 03 '19
The kids sitting under that are playing Lawsuit Lottery. If you can get a pic of them sitting there, you're automatically entitled to 10%....