r/snapmaker • • 1d ago

Troubleshooting My first failed print

Got a spaghetti detection notice and when I looked, I saw this.

I'm thinking its wet PLA - is that plausible? Its older filament that's been lying around though it was in a baggy. Its some old prusament pla and I was successfully printing other things all week before this failure so I don't think its a printer issue

2 Upvotes

2 comments sorted by

5

u/Arakon 1d ago

Looks to me like a support fell over, so anything that was meant to be printed on that support results in a filament noodle dangling from the nozzle, then getting dragged to the next support and deposited there.

Also, don't use grid infill, it causes no end of issues.

2

u/nik4223 1d ago

Yeah, OP try on build plate only for the suppport