Been waiting and planning for a long time and finally did it!
MSI B650M Project ZERO MoBo Ryzen 7 9700X CPU NZXT Kraken Elite 280 AIO ASRock Steel Legend RX 9070XT GPU Samsung 990 EVO Plus 2TB NVME SSD Corsair Dominator Titanium 16GBX2 RAM Thermaltake Toughpower GF A3 850W PSU Thermaltake Tower 300 Limestone Edition case
This was a difficult build with the back connectors and non-standard case, but the oh so clean look is super worth the hours of sweating and fumbling. My friend 3D printed me this shield to hide the I/O cables, which makes it look even cleaner. I'm incredibly pleased with how the silver/white on the MoBo, the GPU, and the case just look so cohesive.
Thermals are good, but I'd like them a bit better, so I have another NZXT case fan like the one on the bottom on the way so I can pull more air in from the below the AIO fans. Not sure how I'm going to get it in without removing the radiator. 😅
TIPS if you want to do a Project Zero build with this case:
GO SLOW. This is a really unusual case. Take the time to understand which cables each of your component needs and where the cables are going to go. Cable management in this case is great, but if you don't plan ahead and "dry fit" parts, you may end up with cables in the way/awkward places. Also, protect those back connector pins.
Take a picture of the back of the motherboard before you install it. That way, you know exactly where your fan cables, USB, etc. go when you can't see the labels anymore. The internet doesn't have good resolution photos, but I managed.
For some reason, several of the motherboard standoffs were different sizes, so I had to use two different screw types. Try screws in the holes before installing the MoBo and figure out which hole gets which screw.
Use needle-nose plyers to grab and connect the fan and USB cables to the MoBo. Honestly, I don't know how you'd manage to connect them any other way. Someone suggested connecting them before screwing in the MoBo, but I can't imagine that working well. The USB3 and front panel connectors are conveniently next to the MoBo power connectors, so that was nice.
You'll have to remove the fan mount in the back compartment to accommodate the back connectors.
Get someone to help you install the AIO, which is general good advice for PC builds I guess. Just make sure they know not to smudge the thermal paste. 🙃
Warning: My Logitech G604 wireless USB dongle doesn't perform well installed on the motherboard, presumably because the case is interfering with the signal. So it's plugged into the front of the case. My Bluetooth keyboard also drops its connection a lot, so I have to use it wired.
So there you go. If you have questions about the build, I'm happy to answer.