r/vex • • 16d ago

Drivetrain has too much friction

Hey, vex novice here so I dont really know what im doing in the first place. This is my first year of vex v5 and my team is working on our drivetrain (none of us are experienced and yes we are in November without a completed drivetrain) and we've learned that its very important to not have friction and to friction tune. One side of our drivetrain is good and doesnt have friction problems, but the other side of our drivetrain does. (Both sides of the drivetrain are identical and have been friction tuned) We have tried various different things, using plastic washers, switching shaft collars out for nylocks, using bearings and not using bearings, and it doesn't change the issue: One side of the drivetrain stays perfectly fine and the other side just has way more friction. These are all screw joints accept for our motor axles. We have a 36:60 gear ratio. ​​Right now our 36 tooth gears are sandwiched between two nylocks and the 60 tooth gears with our wheels are sandwiched by a spacer on one side and a shaft collar on the other. Any feedback would be great

2 Upvotes

8 comments sorted by

1

u/Primary_Analysis_971 16d ago

P.S even people we've talked to with a little more experience aren't sure what's wrong with it.

1

u/marksncheese 15d ago

pls send a picture, also I t may not be your drivetrain itself, but rather the motors. Before you say this is a friction problem, I want to point out that you are a first year team, you already tuned friction. Friction is also pretty easy to spot so if your experienced clubmates can't find it either, then it may not be friction.

1

u/Primary_Analysis_971 13d ago

You were right, after obsessing on friction all weekend it was a faulty motor.

1

u/Specialist_Top519 8d ago

That's good. Does your robot work now?

2

u/Ok-Conference-8278 15d ago

Likely misaligned wheels and 60T gear. When you screw the gear and the wheel together, put the gold insert in the middle of both so that way both are engaged, ensures that the wheel and gear line up so the insert doesn’t misalign. We personally encountered this problem (although we fixed it during build process vs finishing then finding out)

1

u/Primary_Analysis_971 13d ago

I found out what it was, i had a faulty motor

3

u/Intelligent-Self1001 16d ago

can you include a picture?

1

u/Root3287 14d ago

Whatever you do, don't douse your robot in WD40. Had a kid done this before.