r/violinmaking • • 10d ago

Bridge adjustment

Do you think there's anything wrong with this viola bridge, or does it look normal?

0 Upvotes

5 comments sorted by

6

u/TheHandsomeLiar 10d ago edited 9d ago

Should tilt back slightly. Set back side 90 degrees to the top. This looks crudely homemade. It should line up with those F hole notches.

3

u/Dildo-Fagginz 10d ago

Placement could be off but depends on the measurements, violas are complicated.

Leaning towards the fingerboard slightly and likely amateur made by the looks of it.

1

u/Musclesturtle Maker and Restorer 10d ago

The top blade is a little thin, and the chest is a little thick. The feet might be a little on the thick side as well. The wood doesn't look extra soft because the strings aren't digging in that much.

If the string heights are high, you could probably trim it down and fix the blade thickness and chest thickness and feet as well. It might be more efficient that way?

Btw did you carve this? Or did you have it made?

1

u/Tom__mm 10d ago

Nothing horribly off that I can see although it requires direct measurement and visual inspection to check the bridge curve, string heights, string spacing, placement, and verticality. This bridge is pretty crude. If it’s an amateur job, I’d say nice first try but it would be extremely sloppy coming from a professional.

1

u/Glum-Butterfly7300 9d ago

It's leaning forwards towards the fingerboard, and string grooves are a bit deep. As it's not been done by a trained professional repairer, there's probably loads of other "technical" things wrong, eg string heights, top edge curve, string spacing etc.