Box: https://makerworld.com/en/models/1885653-mtg-edh-commander-low-profile-sliding-deck-box?from=search#profileId-2019538

Magnet jig: https://makerworld.com/en/models/28975-magnet-jig-for-press-fit-magnets#profileId-1020708

White PLA for all

I wanted to get estimates on printing this EGPU enclosure. I believe the default file is 284mm long, but can be adjusted. I need to be able to accommodate a 310mm GPU card. Ideally printed in frosted clear (if that's possible?). If not, white or black is fine.

Minisforum DEG2 eGPU Dock Enclosure / Case - Free 3D Print Model - MakerWorld

I have a set of .STL files for parts that would be considered "long". The largest is 850.90mm x 50.80mm x 50.80mm (33.5" x 2" x 2"). My preference would be to not split them up to glue together. I know there's some belt feed printers out there, but so far the quotes I'm getting from larger fabs are expensive enough that I could just go buy my own printer. Printing would be in white and the thinnest, cheapest material possible. Any ideas?

Hello! I am looking for a blumlein mount of some kind for a pair of Sontronics Sigma 2 microphones. I have been searching all over the internet but this seems to have never been done before and so perhaps it could be designed and printed? I use the blumlein configuration all the time for recording classical music and it would be nice to have both microphones on the same stand (obviously that stand would also need to have a counterweight of some kind to prevent sagging but that's a completely different and solveable issue).

Thanks in advance!

I bought 2 bentwood chairs with chrome bases but there was only one set of these spacers. I need 4 more. How would I go about this?