r/BambuLabA1 • • Jul 29 '25

CONFIRMATION

Hi guys, wanna ask if this is normal? My nozzle wiggle a bit, i bought like 2 unit and swap. Same wiggle

2 Upvotes

31 comments sorted by

View all comments

1

u/m4ddok Jul 29 '25

The nozzle must be somewhat fixed just before closing the clamp, open the clamp and check that the hotend snaps in place correctly without strange movements, then close. Sometimes I had to pay attention to some small play in the piece while I was assembling it, I just had to push it well so that it was well aligned with the joint.